We just got in a few Barreto 1320H Commercial Hydraulic Rear Tine Tillers in stock. These are very hard to find and they will sell fast! Full specs below, keep reading.

These are off lease models that are 4-5 years old with Low Hours. They are ready to go to work!

Barreto tilt deck trailer is Sold Separately for $500 if you are interested. We have a few left. They sell for $1600 new.

All units just went through a full service.

All units run like new!

These sell new for over $8400

Delivery and Freight Shipping Services Available- Price based on delivery location

PRODUCT INFORMATION

Length: 77″

Width: 27″

Height: 44″

Tilling Width: 20″

Weight: 560 lbs.

Hydraulic Reservoir: 14 gallons

Ground Drive Forward: 85 ft/minute

Ground Drive Reverse: 85 ft/minute

Marked grease points allow for easy maintenance

Free-wheeling hubs unlock to transport the tiller without starting the engine

Counter-rotating tines cut through sod and hard-packed soil

Hydraulics are easily accessed for maintenance and repair

Simple controls are easy to learn and easy to operate

WHY BARRETO?

DESIGN

All hydraulic means easy maintenance, no downtime, and the most efficient use of your horsepower to get the job done. Moreover, weight, balance, stability, and tine speed allow this tiller to work where others can’t. In addition, the open design allows for easy access to the hydraulics when maintaining or repairing. The heavy design means your tiller works for you instead of tossing you around. As a result, counter-rotating tines break up the most difficult soil, clay, or sod. The tine drive motor is directly mounted to the tine shaft, resulting in a system so durable the original tiller was rented out for more than 20 years. The wheel drive and tine drive work independently of each other to allow your tilling travel speed to be adjusted to the soil conditions.

CONTROLS

The operator-friendly controls couldn’t be easier: one handle to set the tine drive and one to adjust the wheel drive. Engage the clutch lever, use the variable speed drive to adjust the ground speed, and engage the tines when you are ready to till. If you need to stop for a moment, drop the clutch and the tines and wheels will stop, leaving your engine running and ready to pick up where you left off.

ROI

With no belts, chains, or gears to mess with, maintenance is minimal. Also, the hydraulic motor is recessed outside the frame for easy accessibility and removal. In addition, moving parts are protected by seals and plates. Pressure relief valves prevent damage when tines are blocked, reducing the chance of costly repairs. By choosing hydraulics, you’ll increase your utilization and minimize maintenance costs, improving your bottom line because tiller that’s down produces no revenue.